TBS Heli-Nation Talon F7 [TBS-086]




Heli-Nation Talon F7 20x20
Welcome the brand new Talon F7 20x20 Flight Controller. With a F7 processor and 8S capable, Talon is the only 20X20 on the market with a STM32F722RET6 216MHz processor. Built in Betaflight OSD, 6 UARTS, and dedicated LDOs for cleaner gyro and OSD signals makes Talon F7 the most powerful 20X20 FC on the market. One of the features Talon F4 customers praised is the choice of using the 8 pin harness or direct soldering motor ports to the ESC. Heli-Nation has kept that option, while still adding even more features, by letting customers remove the plastic connector to reveal motor ports. The 8 pin harness will be a direct pinout for the forth coming Aikon 20X20 6S ESC! (coming soon).

**WARNING! If you remove the JST connector to direct solder, the pinout is not the same as the JST connector. Please use the diagram below to see the correct pinout. Please pay attention to VBAT and Ground!

【説明】
MCU: STM32F722RET6 216MHz
6-Axis ICM20602 32K
Built in Betaflight OSD
Up to 8S (36V) direct battery power
Buzzer pads for external buzzer
Build in voltage monitoring resistor
5V 2A BEC
Dedicated LDO for gyro for cleaner gyro signal
Dedicated LDO for OSD for cleaner OSD signal
Led strip shares 5V with 5V/2A BEC
6 UARTS: UART1, UART2, UART3, UART4, UART5, UART6
Built in camera control pin with resistor and capacitor
4 Full UARTS with RX/TX pins
Logical pin layout for cleanest build possible
8 pin 4 IN 1 ESC plug (Direct solder motor ports underneath)
Remap able LED pad for additional motor output
TX3 & RX3 can be used for I2C for external compass
5V or 3.3V selectable receiver power
5V, VBAT selectable VTX and CAM power

【セット内容】
pin connector (Aikon compatible)
8 grommets
M3 to M2 nut adapters
M3X5 standoffs

この商品を買った人はこんな商品も買っています