Betafpv F4 Brushless Flight Controller and 16A ESC (BLHeli_32) (XT-30) [BF-00313483]

このBLHeli_32 16A ESCはwhoopドローンBeta85X用にカスタマイズされています。 これはBLHeli_32 ESCが付属する最初のマイクロドローンです。
BLHeli_32は、BLHeliおよびBLHeli_Sに続く第3世代ESCファームウェアです。これは、32ビットMCUを使用するESC用に書かれています。 処理能力の向上に伴い、BLHeli_32では、Dshot 1200など、待ち時間が少なく更新速度が速い高速の入力信号が可能になります。

CPU: STM32F405 (Overclock to 240MHz)
Six-Axis: MPU6000
Size: 26mm x 26mm, whoop mounting pattern
Firmware version: Betaflight OMNIBUSF4SD (OBSD)
OSD: Built-in BetaFlight OSD (STM32 controls OSD chip over SPI in DMA mode)
TX02、RX02 ports is available, so that it could support TBS micro receiver
RSSI ports is available
Buzzer solder pads
Support programable LED like WS2812 etc
Weight: 2.7g

Support BLHELI_32
Support PPM, Oneshot125, Oneshot42, Multishot, Dshot150, Dshot300, Dshot600, Dshot1200
Input voltage: 2-4S lipo
Cotinue current: 16A
Peak current: 35A
Firmware target: BETAFPV-16A-32bit
Motor Connectors: 1.25mm header pins connector

【FC & ESCのアセンブル方法】

Frame: Beta85X frame
Motors: 1105 motors / 1103 motors with 1.5mm header pins connector
Battery: 450mAh 3S battery / 450mAh 4S battery

All the ports are available on this board. So that you could connect any receiver you want on the board. For example.

SFHSS Receiver
Frsky XM/XM+ Receiver
TBS receiver
DSMX receiver

For the details about how to connect the receiver and configure in Betaflight, please check the F4 2S Brushless FC & ESC Manual.

1x F4 2S brushless flight controller
1x 4in1 16A ESC board
4x M1.2x4mm screws
4x M1.4x5mm screws
4x Anti-vibration ruber dampers