F4 Brushed Flight Controller (SPI FUTABA RX + OSD) [BF-00313239 ]

BETAFPV F4 brushed FC board bring a new era in FPV whoop technology. STM32F411 100MHz high performance MCU, 30A lower resistance MOSFETs, SPI Frsky Rx, Build-in Betaflight OSD and polar reversed protection. All of these is backed by the same reliability and warranty of all BETAFPV FC boards.

Six-Axis: MPU6000
ESC: All FETs are rated at 30A maximum. Support 6x15mm/7x20mm/8x20mm/8.5x20mm etc motors.
Size: 26mm x 26mm,fully compatible with the Inductrix quad frame and mounting pattern
Firmware version: Betaflight MATEKF411RX 3.4.0
OSD: Built-in BetaFlight OSD (STM32 controls OSD chip over SPI in DMA mode)
Receiver: SPI Futaba Receiver
Power Cable: 55mm, with JST-PH 2.0 connector, AKA PowerWhoop connector
Weight: 3.7g

1x F4 OSD brushed flight controller (SPI FUTABA SFHSS RX + OSD) ( 55mm PH-JST 2.0 power cable soldered)
4x M1.2x4mm screws (Fit for stock Inductrix frame)
4x M1.4x5mm screws (Fit for Beta75 etc 75mm frame)
4x Anti-vibration ruber dampers